|
Excellent arc stability and precision output of the welding current
The stability of the welding current is a determining factor in the quality of a weld. Our PS 164 power source provides precise welding current output even at low values.
- Two current ranges: 50 Amp. and 160 Amp.: the 50 Amp. version gives 1% precision for your welding current and can be programmed by 1/10 of one amp increments.
- An integrated active surveillance device in the heart of the control system: if the limit of tolerance is exceeded, the equipment shuts itself off instantly and gives an error message telling you the type of fault.
|
 |
|
Complete traceability for all welding parameters
The welding parameters can be archived in two different ways:
- Direct printing of a control ticket from the power source.
- Recording of values onto a Compact Flash (CF) card with transfer to a computer for archiving and exploiting.
|
 |
Extremely low weld seam oxidation thanks to a continuous purging device
Weld seam oxidation can be significantly reduced by a continuous small amount of argon flow across the welding head. The power source automatically tilts the slow purge gas flow towards the protective gas flow during the weld. |
 |
Absolute guarantee of a non oxidized weld seam
An oxygen meter can be interfaced with the power source. The welding cycle can only start when placed below the pre-defined threshold. |
|
|
Gas circuit kept separate until it enters the weld heads chamber
The welding gas remains pure upon entry into the weld heads chamber: essential to ensure the weld quality and assembled parts are free of pollution.
 UHP - closed weld head
MW - closed weld head
|
|
MARKETS - Biochemistry
