|
Whatever your application field is, we offer you the process adapted to your needs and custom design your equipment from standard modules
- TIG/GTAW hot/cold wire process with or without filler metal. Average welding speed 80 to 150 mm/min. Higher speeds are possible depending on the application. Butt welding up to a thickness of approximately 3 mm without filler metal. Filler metal can be used for high tolerance in the weld seam preparations or for metallurgical reasons.
- Plasma process with or without filler metal. Average welding speed 500 to 800 mm/min. Excellent results for thickness of 0.5 to 8 mm. No need to change electrodes during the production cycle. Greater thickness are possible depending on the application. No risk of non-ignition of the electrode (a pilot arc is always present)
- MIG-MAG/GMAW process. Very high deposit rate in all positions. This process, which suits most materials, is widely used in manufacturing medium to large thickness of sheet metals and tubes.
|
 |
|
Our numeric weld control system ensures permanent control of the heat input
The entire weld control was developed on the principle which gives the least possible number of deformations. Thus, you can adapt the welding program for each individual parameter: torch movements, welding current and wire speed, that may also be completely synchronized together.
|
 |
Polysoude precise positioning of the torch in respect to the joint to be welded
Depending on the type of joint to be welded, it is imperative to control the torch positional accuracy to a precision of 1/10 mm. All our modular mechanical components have been designed for high-precision operations.
|
 |
The assurance that you will always be welding in conformity with your procedure
All our power sources are equipped with an integrated active surveillance device in the heart of the control system. This guarantees that instructions are respected. Thus, if any limits are exceeded (current, welding speed…) the equipment will under a controlled condition turn off the weld cycle and instantly provide the operator with an error message showing the type of fault.
|
 |
|
Limited space required – totally safe for the operator
Our solutions generally take up less ground space than a “robotic” installation. Furthermore, during the welding phase, the operator can stay close to the equipment to load or unload the parts and thus reduce non-productive time to a minimum. There is never any question of his safety being compromised.
 TS series
Strip welder
Modular welding lathe
|
 |
Markets - Small, medium and large series part assembly
